Module Compatibility Calculator

Module Compatibility Calculator

Use this solar calculator/compatibility calculator to help determine the electrical compatibility of PV modules with the APsystems microinverter family.
Refer to the PV module manufacturer's datasheet for correct values. All fields are required.

Solar Module Basic Information Input

Please make sure that the below input data is consistent with the parameter table provided by the module manufacturer.

Voc (Voltage at Open Circuit)

*

V

Please provide a valid number.

Vmp(Voltage at Maximum Power)

*

V

Please provide a valid number.

Isc (Short Circuit Current)

*

A

Please provide a valid number.

Temperature Coefficient of Isc

*

Please provide a valid number.

Temperature Coefficient of Voc

*

Please provide a valid number.

Please enter the local air temperature at the installation site. The ASHRAE Handbook is the recommended source for weather data in a particular location.

Maximum local temperature

*

℃

Please provide a valid number.

Minimum local temperature

*

℃

Please provide a valid number.

Use ECU?

Please ensure that the filled parameters are accurate, reasonable and valid. APsystems is not responsible for my use of the data provided herein.

Must be checked

Compatibility Results

Product	Voc at Highest Temp V	Voc at Lowest Temp V	Vmp at Highest Temp V	Vmp at Lowest Temp V	Isc at Highest Temp A	Result

Copyright © 2016-2023 Altenergy Power System Inc. (APsystems),All Rights Reserved

Introduction

Module Compatibility Calculator

Use this solar calculator/compatibility calculator to help determine the electrical compatibility of PV modules with the APsystems microinverter family. Refer to the PV module manufacturer's datasheet for correct values. All fields are required.

Parameter Introduction

Voc (Voltage at Open Circuit)

The Voc is the voltage that is read with a voltmeter or multimeter when the module is not connected to any load.

Vmp(Voltage at Maximum Power)

The Vmp is the voltage that is read with a voltmeter or multimeter when the module is producing maximum power.

Temperature Coefficient of Voc

Coefficient used to determine effect of temperature on a PV module's open circuit voltage. Contact your manufacturer if this value is not listed on the datasheet.

Isc (Short Circuit Current)

This is the amount of current that flows through the electrical leads when shorted--essentially the maximum amount of current that the PV module can source.

Temperature Coefficient of Isc

Coefficient used to determine effect of temperature on a PV module's short circuit current. Contact your manufacturer if this value is not listed on the datasheet.

Maximum local temperature

Enter the highest average temperature when sunlight shines on the PV array. The ASHRAE Handbook is the recommended source for weather data in a particular location or you can look up the Extreme Low Temperatures for your location by clicking here.

Minimum local temperature

Enter the lowest average temperature when sunlight shines on the PV array. The ASHRAE Handbook is the recommended source for weather data in a particular location or you can look up the Extreme Low Temperatures for your location by clicking here.

Introduction

Parameter Introduction

Introduction

About Privacy Agreement

Please make sure that the input data of Voc, Vmp, Temperature Coefficient of Voc, Isc ,Temperature Coefficient of Isc is consistent with the parameter table provided by the module manufacturer.

Please ensure that the input data of Maximum local temperature, Minimum local temperature is reasonable.

Introduction

Information Introduction